Description
The recommended method for creating the sanding/polishing
band for our Finger Sanders is to cut the polishing paper to the correct width
for the whole 11
length of the polishing paper. Determine the uncoated side of the polishing
paper so that you are taping the paper only side and not the abrasive polish
side. Meet the ends of the paper squarely and take a 3 strip of the 3M
SUPER BOND TAPE and tape the ends together. The tape should go lengthwise with
tape extending 1-1/2
up both ends of the paper. Check to make sure that no tape is exposed from the
outer edge of the polishing paper. Make sure that when mounting the band on the
Finger Sander that the abrasive side is facing outward. You might need to turn
it inside out. It is recommended that the section of tape that is used is clean
and not previously stuck on another item such as a finger.
